- How To Install
- Help / FAQ
1. Prepare your Pebble Steel by cleaning its surface with a microfiber cloth to remove all residue, dust, gunk, etc.
2. Really make sure that there isn't any dust on the surface of the watch.
3. Slowly pull the #1 tab to remove the first of two protector films.
4. Use your other hand to hold the #2 tab as a "handle".
5. Slowly guide the protector over the surface of the watch. It helps to line up one side of the protector first and then (with your eyes) to visually line up a second side of the protector to make sure it's properly lined up.
6. Slowly lower the protector down to the surface of the watch.
7. Use your fingers to rub the rest of the protector to get all the rest of the air bubbles out.
8. Pull the #2 tab to remove the second protective layer.
9. If any corners aren't adhering use your fingernail to push them down.